1、功能说明
    1、GTIMA5 利用CH1 CH2 CH3 CH4 CC值产生定时中断，翻转IO电平

2、使用环境
    软件开发环境：KEIL MDK-ARM V5.34
    软件开发环境：IAR EWARM 8.50.1

    芯片支持：
        N32H730  
        N32H735   
        N32H735EC
        N32H760
        N32H762
        N32H765
        N32H765EC
        N32H785
        N32H785EC
        N32H787

3、使用说明
    系统配置；
        1、时钟源：HSI+PLL
        2、系统时钟频率：
            M7核: 600MHz
        3、中断：
			GTIMA5 比较中断打开
        4、端口配置：
			PC6选择为IO输出
			PC7选择为IO输出
			PC8选择为IO输出
			PC9选择为IO输出
        5、TIM：
			GTIMA5输出冻结模式，CH1 CH2 CH3 CH4比较值产生中断
    使用方法：
        1、编译后打开调试模式，用示波器或者逻辑分析仪观察PC6、PC7、PC8、PC9的波形
        2、程序运行后，对应通道达到比较值后，比较值累加并翻转对应IO口电平
4、注意事项
    无
    
1. Function description
    1. GTIMA5 uses the CH1 CH2 CH3 CH4 CC value to generate a timing interrupt and flip the IO level

2. Development environment
    Software development environment: KEIL MDK-ARM V5.34
    Software development environment: IAR EWARM 8.50.1

    Supported chips:
        N32H730  
        N32H735   
        N32H735EC
        N32H760
        N32H762
        N32H765
        N32H765EC
        N32H785
        N32H785EC
        N32H787

3. How to use
   System Configuration:
        1. Clock source: HSI+PLL
        2. System Clock frequency: 
            M7 Core:     600MHz
        3. Interruption:
			GTIMA5 compare interrupt is turned on
        4. Port configuration:
			PC6 is selected as IO output
			PC7 is selected as IO output
			PC8 is selected as IO output
			PC9 is selected as IO output
        5. TIM:
			GTIMA5 output freeze mode, CH1 CH2 CH3 CH4 compare value interrupt
    Instructions:
        1. After compiling, turn on the debug mode, and use an oscilloscope or logic analyzer to observe the waveforms of PC6, PC7, PC8, and PC9
        2. After the program runs, after the corresponding channel reaches the comparison value, the comparison value accumulates and flips the corresponding IO port level
4. Attention
    None

